Collection: PRESSING/APPLICATION INSTRUCTIONS!
*Keep in mind each heat press is different you may need to adjust temperature accordingly.
NO COVER SHEET NEEDED FOR SCREEN PRINT TRANSFERS!
*SEQUIN/CHENILLE PATCHES- PRE-PRESS GARMENT TO REMOVE MOISTURE. MUST USE COVER SHEET SUCH AS PARCHMENT PAPER OR TEFLON TO PROTECT PRESS. TEMPERATURE 325-350 FOR 20 SECONDS. HEAVY PRESSURE. TURN SHIRT INSIDE OUT AND PRESS AGAIN FOR 20 SECONDS. PLEASE SEE BELOW FOR WASHING INSTRUCTIONS!
* (SINGLE COLOR)-PRE-PRESS GARMENT TO REMOVE MOISTURE. TEMPERATURE 330-350 FOR 15-20 SECONDS, HEAVY PRESSURE (HOT PEEL). Slowly peel the transfer to ensure it is sticking, if the transfer is not sticking repress for 7-10 seconds.
*PUFF PRINTS- PRE-PRESS GARMENT TO REMOVE MOISTURE. TEMPERATURE 350 FOR 7 SECONDS. HEAVY PRESSURE (HOT PEEL)
*THIN MATTE CLEAR FILM TRANSFERS (FULL COLOR)- PRE-PRESS GARMENT TO REMOVE MOISTURE. TEMPERATURE 330-350 FOR 15-20 SECONDS, HEAVY PRESSURE. These are hot peel however, if you have any issues peeling hot a trouble shooting method is rubbing the clear film with a hand cloth or any nearby cloth to help slightly cool before peeling away the film (peel from top corner of the film not bottom corner of film) I also repress with a piece of butcher paper over the design just to ensure its set into the shirt. Start with the lowest recommended temperature if not sticking then up the temperature.
*SUBLIMATION TRANSFERS- PRE-PRESS GARMENT TO REMOVE MOISTURE. TEMERATURE 400 FOR 60 SECONDS, MEDIUM PRESSURE. USE BUTCHER PAPER INSIDE SHIRT AND OVER TRANSFER TO PROTECT YOUR HEAT PRESS. SUBLIMATION MUST BE APPLIED TO AT LEAST 50% POLYESTER OR HIGHER AND MUST BE A WHITE OR LIGHT-COLORED T-SHIRT. KEEP IN MIND THE HIGHER THE POLYESTER COUNT THE MORE VIBRANT THE DESIGN WILL APPEAR.
*WASHING CARE INSTRUCTIONS FOR T-SHIRTS- TURN INSIDE OUT WASH IN COLD WATER, AIR DRY OR TUMBLE DRY LOW.
*UV DTF TRANSFERS- PERMANENT ADHESIVE TRANSFERS. NO HEAT REQUIRED. CAN BE APPLIED ON GLASS OR HARD PLASTIC SURFACES. TO APPLY TRANSFER FIRST USE A SQUEEGEE TO ENSURE THE DESIGN TRANSFERS TO THE CLEAR FILM. SLOWLY PEEL FROM WHITE BACKING. CAREFULLY APPLY TRANSFER TO DESIRED SURFACE, PLEASE KEEP IN MIND THE ADHESIVE IS VERY STRONG SO ONCE IT TOUCHES THE SURFACE IT WILL NOT BE ABLE TO BE PEELED BACK UP. ONCE APPLIED BEFORE PEELING THE CLEAR FILM USE THE SQUEEGEE AND RUB THE ENTIRE TRANSFER TO REMOVE ANY AIR BUBBLES AND TO ENSURE THE TRANSFER IS FULLY APPLIED, SLOWLY PEEL BACK THE CLEAR FILM AND ENJOY YOUR NEW CUP!!!
WASHING/CARE INSTRUCTIONS FOR UV DTF- GENTLE WASH AND RISE! DO NOT SOAK ITEM OR PUT IN DISH WASHER OR MICROWAVE!